Beams
0 ContainersFiles in Beams
ACI 318-08 Rec Sec. Mx -Q-Torsion Design
v6.3 Design of Rectangular Beam Sec. subjected to (Mx ,shear &Torsion) according to ACI 318-08 code.
Calculation Reference
ACI 318-08
Prestre...
ANALYSIS & DESIGN OF RC BEAM AS PER ACI 318-08
The Basic Concept: When a concrete beam bends under load, the concrete on one side gets compressed while the other side gets stretched (tension). S...
Beam Investigation.xls
The purpose of this spreadsheet is to investigate the capacity of reinforced concrete beam with a maximum of three (3) layers of compression rein...
Beam with stress.xls
Single-Span Beam Analysis with Bending Stress Check Analyses a single-span beam that is simply supported, propped, fixed at both ends or cantilever...
BEAMANAL (metric).xls
Single and Continuous Beam Analysis, Metric (Shear, Moment, Slope, Deflection) Analyses prismatic beams under almost any combination of loads, in m...
BEAMANAL.xls
Single-Span and Continuous Beam Analysis with AISC ASD Check Analyses a beam of constant section under almost any combination of loads, either as a...
BMREACT.xls
Allowable Steel Beam End Reaction and End Moment for Connection Design (AISC ASD) Works out the end reaction and end moment a steel beam connection...
BMREINF9.xls
Reinforcing Existing Steel Members: Stress Check and Welds (AISC ASD) Checks an existing steel beam or beam-column that has been strengthened with ...
BOEF.xls
Beam on Elastic Foundation: Finite Beam with Free Ends Analyses a beam of finite length with both ends free, resting on an elastic (Winkler) founda...
Cold-Formed Channel Purlin Design - Biaxial Bending and Deflection with Sag Rods
Cold-Formed Channel Purlin Design - Biaxial Bending and Deflection with Sag Rods An allowable stress check of a cold-formed lipped-channel purlin o...
Concrete Beam Design (CSA A23.1-94)
Here's my first attempt to do something more stand-alone. Feel free to comment, point out errors or improve
Calculation Reference Con...
CRANE GIRDER DESIGN BS5950
Calculation Reference
Crane Design
BS5950
Structural Design
...
Crane runway design based on DIN standard
Parameters
Hoist type, Hoisting speed, VH, Operation, Type of girder, Safe working load, Support length, L, , Crane group , Girder w...
Design of RCC Rectangular Beams as per IS 456-2000
- GENERAL : The design of reinforcement for Limit State of Collapse in Flexure and Shear for Rectangular Beam Section is ca...
Design of RCC T Beams as per IS 456-2000
- GENERAL : The design of reinforcement for Limit State of Collapse in Flexure and Shear for T Beam Section is carried out as per I...
Equialent UDL from Point Loads in Beam
Calculating the equivalent distributed load from a set of point loads in a beam can be highly beneficial to an engineer for several reasons...



















