XBRACING.xls
Description
Tension-Only X-Braced Frame: Member Forces, Reactions and Storey Drift (1 to 10 Storeys)
Analyses a single-bay vertical bent braced in every storey with tension-only X-bracing, under lateral loads at each floor. There is one sheet for each number of storeys from 1 to 10. Each gives the force in every column segment, beam and brace, the support reactions, and the horizontal deflection at each level, with a labelled elevation of the bent.
Method
- Tension-only bracing: in each storey one diagonal takes all the shear in tension and the other is assumed to buckle and carry nothing
- Member forces and reactions by statics for a pin-jointed frame
- Storey deflections by virtual work, Δ = ΣFuL/AE, with a unit load applied at each level in turn
Inputs
- Bent width and storey heights
- Lateral load at each level (and at the base)
- Cross-sectional area of each column segment, beam and brace; modulus of elasticity
Outputs
- Axial force in every member (compression positive, tension negative), brace angles and lengths
- Vertical reactions (including uplift) and horizontal reaction
- Total drift and drift ratio (H/Δ) at each level, and the interstorey drift and ratio (h/Δ)
The stored two-storey example (20 ft wide, storeys of 19 ft and 18 ft, loads of 9.25 and 4.5 kips, braces of 1.44 in²) gives brace forces of 18.97 and 6.05 kips in tension, vertical reactions of 17.11 kips at the column bases (one in compression, one in uplift), and drifts of 0.246 in. at level 1 and 0.340 in. at the roof (H/1305). We confirmed these with an independent truss analysis.
Please note
- All joints are treated as pinned, and deflections are for the joints on the left side of the bent. Gravity loads and P-delta effects are not included.
- The sheets give forces and drift only; they do not size or check the members.
- US customary units. No macros. Sheets protected without a password.
- Written by Alex Tomanovich, P.E.
Calculation Preview
Full download access to any calculation is available to users with a paid or awarded subscription (XLC Pro).
Subscriptions are free to contributors to the site, alternatively they can be purchased.
Click here for information on subscriptions.
Comments: 2
×
18 years ago
I was brought to my attention that in the "XBRACING.xls" workbook in the X(4), X(7), and X(10) worksheets there were a few incorrect cell references in the Member Data table for the drift analysis which resulted in the display of some incorrect column segment lengths and X-bracing lengths. The correct lengths of these members were displayed in the sketch. The incorrect values shown in the table did not effect the results, as the values (cell references) in the table were not used anywhere else.
This workbook is now version 1.1.
This workbook is now version 1.1.
This has been corrected, and the workbook is now version 1.2.