Pressure Vessel Design Calculation (Cone)
T provides a worst case required thickness for nozzle analysis for a nozzle located on the large end of the cone and located on the long seam weld.
The UG-16(b) minimum thickness requirement has not been taken into consideration here.
Discontinuity checks which are required for each end of the cone when it is welded to a straight shell are not included in this sheet.
This sheet cannot be used to check for allowable exterior pressure loads.
This sheet is for educational use only - use at your own risk.
Pressure Vessel Design
Pressure Vessel Handbook
Roarks Formulas for Stress and Strain
16 May 2011
This download is for Registered Users Only.
Perhaps you need to login or register.