Anchor Reinforcement
Description
Anchor Reinforcement for Tension and Shear to ACI 318-08 Appendix D
Sizes the reinforcing bars that can be used in place of the concrete breakout strength of cast-in anchor bolts, to Sections D.5.2.9 (tension) and D.6.2.9 (shear) of ACI 318-08. One sheet covers vertical bars beside the anchors for tension; the other covers a hairpin bar for shear.
Method
- Required bar area As,min = N/(0.75fy) or V/(0.75fy) (tension: all vertical bars; shear: two legs of one hairpin)
- Straight development length in tension to Section 12.2.2, ld = fyψtψedb/(20λ√f′c) × As,req/As,prov, or 3.25 times the hooked-bar length to Section 21.7.5 where high seismic risk is selected
- Tension only: the minimum anchor embedment hef,min = ld + clear cover + 0.7 × anchor-to-bar distance
Inputs
- Required reinforcement strength N or V (kips), bar size (#3 to #18) and, for tension, number of bars and estimated embedment
- fy and f′c (ksi); lightweight concrete, epoxy coating, top bar (shear sheet) and high seismic risk options
- As,req/As,prov, bar spacing, cover and anchor-to-bar distance
Outputs
Development length, required and provided bar areas, and (tension) required and provided embedment, each with a ratio.
The stored tension example, N = 20 kips with four #4 bars, fy = 60 ksi and f′c = 4 ksi, gives ld = 17.6 in. and hef,min = 23.8 in. against 24 in. provided (ratio 0.99), with bar area ratio 0.57. The shear example, V = 9.85 kips with a #3 hairpin, gives an area ratio of 0.99 and ld = 18.5 in.
Please note
- The edge distance is not an input. Check yourself that the anchor-to-bar distance does not exceed 0.5hef or the edge distance less cover, and provide containment steel where the edge distance is under 1.5hef.
- The divisor 20 is used for all bar sizes, which is conservative for #6 and smaller bars. The 12 in. minimum development length is not applied. The shear sheet does not check the hairpin’s anchorage length against the geometry.
- US customary units. No macros. ACI 318-08 has since been superseded.
- Reference: ACI 318-08; Ronald A. Cook, Strength Design of Anchorage to Concrete.
Calculation Preview
Full download access to any calculation is available to users with a paid or awarded subscription (XLC Pro).
Subscriptions are free to contributors to the site, alternatively they can be purchased.
Click here for information on subscriptions.
Comments: 4
×